As we all know, although China is a major producer of fasteners, but due to backward technology, most fasteners are imported equipment. However, with the improvement of the level of research and development in China, domestic fastener equipment has risen to a certain height. It is estimated that by 2020, production equipment and testing equipment in China’s fastener enterprises will fully implement domestic production to achieve more than 80%. .

In view of the current situation, the overall hardware industry in 2013 has a gap from our imagination. Under this form, we can see that the screw economy of the entire international market, including the domestic market economy, is not enough. The motivation. The ability to influence is also a serious deficiency, that is to say, this is the period of time when the economic recovery has had the least ability to rebound. From the second quarter analysis report of standard parts, we can see that China’s overall export volume has already reached a low level and has not achieved the expected breakthrough, which is very capable of killing. We can look at our own statistics and show that in this quarter, the total output value of standard parts that we can achieve is about 73.2 billion yuan, a year-on-year increase of only 0.5%, but this can be said to be very high compared to last year's growth rate. Small. And we can see a lot of falling data on export volume.

According to customs statistics, the standard parts industry's export of screw products totaled US$5.46 billion, showing a huge negative growth, which was a decrease of -9.1%. The import side of the screw products was US$3.25 billion. This data also showed negative growth. , And also reached two digits. In terms of exports, it is also very unsatisfactory. Although there has been an increase in production, the export screw products have increased by -4% year-on-year. It can be said that the entire standard parts industry has experienced an overall decline in this quarter.

In this series of data, the development of the hardware industry we can see the overall standard parts industry has not been able to open the ability to rely on independent power to generate huge power. Although China is a major producer of fasteners, but because of the relatively low level of research and development in China, many of the fastener companies, most of the fastener equipment are imported, and we can see a lot of domestic screws The equipment is relatively simple, and then there is a variety of problems that are easily encountered in the use of domestically produced fasteners. In the face of this series of problems, most fasteners in China have to be made. Enterprises began to use foreign fastener production equipment and testing equipment.

In June 2013, Luo Baihui, secretary-general of the International Mould, Hardware and Plastics Industry Suppliers Association, investigated a large number of domestic fastener companies and found that the level of research and development in China has improved to some extent, and domestic screw equipment has reached a high level. It is estimated that by 2020, the production equipment and testing equipment in China's fastener enterprises will fully implement more than 80% domestic production.

According to research, during the entire year of 2012, the production of fasteners in China has begun to show significant improvement. With the support of the government, we can find that the investment has reached 798.15 billion yuan, which has increased compared to 2012. 12.73% and in the production process can reach an output value of 775.496 billion yuan, which is also a growth rate of 12.25% or more. Under this kind of development, during the period from 2013 to 2018, even if the rapid growth of such screw equipment will not be maintained every year, we can also predict the fastener equipment in our country's fastener production equipment. Began to go localization.